ObiWiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Diskpart clean USB drive ======

Sometimes I use USB to install non-windows stuff and then I may write image directly to USB with Etcher tool etc. These images may contain multiple partitions and returning USB back to single volume fat drive can be tricky. Windows has inbuilt tool called diskpart which usually can be used to clean USB disk and recover it back to single partition mode.

Open Command Prompt/Powershell as admin, run command **diskpart ** (do not insert USB yet), then in diskpart:

   - **DISKPART> automount disable **  (Disables automount of disks)
  - Insert USB disk
  - Find and select correct disk, failure in this step may end you deleting your harddrive. Disk size is way to identify correct disk \\  \\ **DISKPART> list disk ** \\  \\ **Disk ### Status Size Free Dyn Gpt** \\ **——– ————- ——- ——- — —** \\ **Disk 0 Online 931 GB 2048 KB *** \\ **Disk 1 Online 7452 GB 1024 KB *** \\ **Disk 2 Online 1907 GB 0 B *** \\ **Disk 3 Online 14 GB 2861 MB** \\  \\ **DISKPART> select disk 3** \\  \\ **DISKPART> list disk** \\  \\ **Disk ### Status Size Free Dyn Gpt** \\ **——– ————- ——- ——- — —** \\ **Disk 0 Online 931 GB 2048 KB *** \\ **Disk 1 Online 7452 GB 1024 KB *** \\ **Disk 2 Online 1907 GB 0 B *** \\ *** Disk 3 Online 14 GB 2861 MB** \\  \\
  - Then wipe the selected disk \\  \\ **DISKPART> clean**
  - I think sometimes clean does not clean partition table fully, causing errors later on. Try to get around this changing partition table \\  \\ **DISKPART> convert gpt** \\  \\ **DiskPart successfully converted the selected disk to GPT format.**
  - Create partition \\  \\ **DISKPART> create part pri** \\  \\ **DiskPart succeeded in creating the specified partition.**
  - Format partition \\  \\ **DISKPART> format fs=fat32 quick** \\  \\ **100 percent completed**
  - Close diskpart, remove drive and plug it in again